What does the fault code F382 for the endress hauser flowmeter | e+h mass flowmeter mean?

『Endress Hauser flowmeter』Related information(v cone flow meter|rotary gas meter|gallon meter|gear meter|metal tube rotameter|glass tube rotameter|nutating disk meter|transit time ultrasonic flow meter|wedge flow meter|pd meters|hydraulic flow meter|ultrasonic water flow meter|water flow meter|air flow meter|magnetic water flow meter|oxygen flow meter|gas flow meter|argon flow meter|air velocity meter|gasoline flow meter|fuel flow meter|ultrasonic water meter|digital water meter|nitrogen flow meter|solid flow meter|Oxygen tank flow meter|digital water flow meter|diesel fuel flow meter|steam flow meter|02 flow meter|compressed air flow meter|oil flow meter|liquid flow meter)

1. I am at the construction site, and I will record the Bluetooth debugging of the e+h flowmeter once. The Bluetooth debugging of the e+h flowmeter is an important task at the construction site, and the following is a detailed debugging record.

1. Introduction to Flow Meter: The Endress+Hauser Promag W series industrial measuring instruments were used for this debugging.

. This flowmeter supports pure Bluetooth debugging and does not come with a touch screen, so it needs to be set up by connecting to a mobile app via Bluetooth.

2. Preparation for mobile app installation before debugging: Firstly, the SmartBlue Bluetooth debugging app needs to be installed on the phone, with the latest version being Endress Hauser SmartBlue-v1.11.0- (2439).

. This version supports Promag W series flow meters, which can be obtained from the E+H technical department or by private message to relevant technical personnel.

Step 1 of Debugging: Connect Bluetooth and turn on Bluetooth: Ensure that the Bluetooth function of the phone is turned on and close to the flowmeter.

. Scanning device: The system will automatically scan nearby Bluetooth devices to find the flow meter with the strongest signal. Verify the name: Confirm that the scanned flowmeter name matches the one on the nameplate. Enter password: During the connection process, a username and password are required. The username is admin, and the password is the device name+18000 on the transmitter nameplate (pay attention to capitalization). For example, if the equipment on the nameplate is designated as V706ED, the password is V706ED18000. Step 2: Enter the settings interface and open the APP: Start the SmartBlue APP, and the system will automatically connect to the paired flowmeter. Enter parameter settings: Follow the operation guide step by step to enter the flowmeter settings interface. Step 3: Adjust parameters and flow units: Adjust the instantaneous flow unit to m3/h and the cumulative flow unit to m3. Set display content: Adjust the instantaneous flow and cumulative flow to be displayed simultaneously. In the display settings, select Display 1 and Display 2 as the content to be displayed. Turn off air traffic detection: To avoid incorrect flow when the pump stops, it is recommended to turn off the air traffic detection function. Modify current output: Due to the need for HART functionality, modify the current output to 4-20mA HART output.

4. HART communication settings: By connecting the flowmeter to the HART module of Songmao, the current signal of the flowmeter can be converted to 485 protocol, which facilitates the reading of cumulative flow and is very important for statistical processing.

.

Fifth, Debugging Summary: The Bluetooth debugging process of the e+h flowmeter was smooth, and the flowmeter was successfully connected and the relevant parameters were adjusted through the SmartBlue APP.

. During the debugging process, it is important to pay attention to the following points: ensure that the Bluetooth function of the phone is turned on and close to the flow meter. Verify that the name of the flowmeter matches the one on the nameplate to avoid connecting the wrong equipment. Enter the correct username and password to ensure successful connection to the flow meter. Adjust parameters such as flow units, display content, and current output according to actual needs. If necessary, the current signal of the flowmeter can be converted to 48

『SILVER Official Website SERVICE』